Avaya J169 User Manual page 4

Regulatory Statements
1
Australia Statements
2
Handset Magnets Statement:
3
Danger:
The handset receiver contains magnetic devices that can
4
attract small metallic objects. Care should be taken to avoid
5
personal injury.
6
Industry Canada (IC) Statements
7
RSS Standards Statement
8
This device complies with Industry Canada licence-exempt RSS
9
standard(s). Operation is subject to the following two conditions:
10
1. This device may not cause interference, and
11
2. This device must accept any interference, including
12
interference that may cause undesired operation of the
13
device.
14
Le présent appareil est conforme aux CNR d'Industrie Canada
15
applicables aux appareils radio exempts de licence. L'exploitation est
16
autorisée aux deux conditions suivantes:
17
1. L'appareil ne doit pas produire de brouillage, et
18
2. L'utilisateur de l'appareil doit accepter tout brouillage
19
radioélectrique subi, même si le brouillage est susceptible
20
d'en compromettre le fonctionnement.
21
Radio Transmitter Statement
22
Under Industry Canada regulations, this radio transmitter may only
23
operate using an antenna of a type and maximum (or lesser) gain
24
approved for the transmitter by Industry Canada. To reduce potential
25
radio interference to other users, the antenna type and its gain
26
should be so chosen that the equivalent isotropically radiated power
27
(EIRP) is not more than that necessary for successful
28
communication.
29
Conformément à la réglementation d'Industrie Canada, le présent
30
émetteur radio peut fonctionner avec une antenne d'un type et d'un
31
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
32
Canada. Dans le but de réduire les risques de brouillage
33
radioélectrique à l'intention des autres utilisateurs, il faut choisir le
34
type d'antenne et son gain de sorte que la puissance isotrope
35
rayonnée équivalente ne dépasse pas l'intensité nécessaire à
36
l'établissement d'une communication satisfaisante.
37
This Class B digital apparatus complies with Canadian ICES-003.
38
Cet appareil numérique de la classe B est conforme à la norme
39
NMB-003 du Canada.
40
Radiation Exposure Statement
41
This equipment complies with FCC & IC RSS102 radiation exposure
42
limits set forth for an uncontrolled environment. This equipment
43
should be installed and operated with minimum distance 20cm
44
between the radiator & your body. This transmitter must not be co-
45
located or operating in conjunction with any other antenna or
46
transmitter.
47
Cet équipement est conforme aux limites d'exposition aux
48
rayonnements ISEDétablies pour un environnement non contrôlé.
49
Cet équipement doit être installé et utilisé avec un minimum de 20
50
cm de distance entre la source de rayonnement et votre corps.
51
Japan Statements
52
Class B Statement
53
This is a Class B product based on the standard of the VCCI Council.
54
If this is used near a radio or television receiver in a domestic
55
environment, it may cause radio interference. Install and use the
56
equipment according to the instruction manual.
57
58
Denan Power Cord Statement
59
Danger:
Please be careful of the following while installing the
60
equipment:
61
• Please only use the connecting cables, power cord, and
62
AC adapters shipped with the equipment or specified by
63
Avaya to be used with the equipment. If you use any
64
other equipment, it may cause failures, malfunctioning,
65
or fire.
66
• Power cords shipped with this equipment must not be
67
used with any other equipment. In case the above
68
guidelines are not followed, it may lead to death or
69
severe injury.
70
71
本製品を安全にご使用頂くため、以下のことにご注意ください。
72
• 接続ケーブル、電源コード、AC アダプタなどの部品は、必ず
73
製品に同梱されております添付品または指定品をご使用くだ
74
さい。添付品指定品以外の部品をご使用になると故障や動作
75
不良、火災の原因となることがあります。
76
• 同梱されております付属の電源コードを他の機器には使用し
77
ないでください。上記注意事項を守らないと、死亡や大怪我
78
など人身事故の原因となることがあります。
79
México Statement
80
The operation of this equipment is subject to the following two
81
conditions:
82
1. It is possible that this equipment or device may not cause
83
harmful interference, and
84
2. This equipment or device must accept any interference,
85
including interference that may cause undesired operation.
86
La operación de este equipo está sujeta a las siguientes dos
87
condiciones:
88
1. Es posible que este equipo o dispositivo no cause
89
interferencia perjudicial y
90
2. Este equipo o dispositivo debe aceptar cualquier
91
interferencia, incluyendo la que pueda causar su operación
92
no deseada.
93
Power over Ethernet (PoE) Statement
94
This equipment must be connected to PoE networks without routing
95
to the outside plant.
96
Taiwan Low Power Radio Waves Radiated Devices Statement
97
802.11b/802.11g/BT:
98
Article 12 — Without permission granted by the NCC, any company,
99
enterprise, or user is not allowed to change frequency, enhance
100
transmitting power or alter original characteristic as well as
101
performance to an approved low power radio-frequency devices.
102
Article 14 — The low power radio-frequency devices shall not
103
influence aircraft security and interfere legal communications; If
104
found, the user shall cease operating immediately until no
105
interference is achieved. The said legal communications means radio
106
communications is operated in compliance with the
107
Telecommunications Act. The low power radio-frequency devices
108
must be susceptible with the interference from legal communications
109
or ISM radio wave radiated devices.
110
111