IBM System x3800 Problem Determination And Service Manual page 108

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, "Parts listing, System x3800 Type 8866," on page 107 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error message
POST reporting memory event: DIMM Disabled -
Failed POST/BIOS Memory Test. Chassis
Number = X. Memory Card = Y. Memory DIMM
= Z.
POST reporting memory event: DIMM Disabled -
Failed ECC Test. Chassis Number = X. Memory
Card = Y. Memory DIMM = Z.
POST reporting memory event: DIMM Disabled -
Failed ECC Test. Chassis Number = X. Memory
Card = Y. Memory DIMM = Z.
Unknown SERR/PERR detected on PCI bus
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
Address of special cycle DPE on PCI primary
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
Master read parity error on PCI primary
Chassis#=4 Slot#=2 Bus#=3 Dev.ID=0xaa99
Vend.ID=0xccbb Status=0xeedd DevFun#=0xff
Received target parity error on PCI primary
Chassis#=X Slot#=Y Bus#=Z Dev.ID=0xSSSS
Vend.ID=0xTTTT Status=0xUUUU
DevFun#=0xVV
92
IBM System x3800 Type 8866: Problem Determination and Service Guide
Action
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
1. Reseat the DIMM.
2. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
3. Replace the DIMM.
4. If the DIMM was disabled by the user, run the
Configuration/Setup Utility program and enable the DIMM.
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.
1. If the slot number is greater than 0, complete the following
steps:
a. Reseat the adapter.
b. Replace the adapter.
2. If the slot number is 0, replace the PCI board.