Ethernet Oam - D-Link DGS-3700-12 User Manual

Ethernet OAM

The Ethernet OAM section includes Ethernet OAM Settings, Ethernet OAM Configuraion Settings, Ethernet OAM
Event Log, and Ethernet OAM Statistics.
Ethernet OAM Settings
This window is used to configure the ports Ethernet OAM mode. In Active mode the ports can initiate OAM discovery
and start or stop remote loopback. When a port in OAM enabled, any change to the OAM mode will cause the OAM
discovery to be restarted.
To view this window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below:
The following parameters can be configured:
Parameter
From Port /To Port
Mode
State
Remote Loopback
Received Remote
Loopback
Click Apply to implement changes.
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 10- 15 Ethernet OAM Settings window
Description
Specify a range of ports to be configured.
Specify to operate in either Active mode or Passive mode The default mode is Active.
Specify that the OAM function state is Enabled or Disabled. The default state is Disabled.
Specify to Start or Stop the OAM remote loopback function.
Specify whether to Process or to Ignore the received Ethernet OAM remote loopback
function. The default method is Ignore.
278