D-Link DGS-3700-12 User Manual page 113

The following parameters may be viewed or modified:
Parameter
VLAN ID
VLAN Name
Query Expiry Time
Query Interval (1-65535 sec)
Max Response Time
(1-25 sec)
Robustness Value (1-7)
Last Listener Query Interval
(1-25 sec)
Data Driven Group Expiry
Time (1-65535)
Querier State
Fast Done
State
Report Suppression
Data Driven Learning State
Data Driven Learning Aged
Out
Version
Querier Role
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet User Manual
Figure 4- 54 MLD Snooping Parameters Settings window
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN for which
to modify the MLD Snooping Settings.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which
to modify the MLD Snooping Settings.
Displays the query expiry time in seconds.
Allows the entry of a value between 1 and 65535 seconds, with a default of 125
seconds. This specifies the length of time between sending MLD queries.
This determines the maximum amount of time in seconds allowed to wait for a
response for MLD port listeners. The Max Response Time field allows an entry
between 1 and 25 (seconds). Default = 10.
Provides fine-tuning to allow for expected packet loss on a subnet. The user may
choose a value between 1 and 7 with a default setting of 2. If a subnet is expected to
be lossy, the user may wish to increase this interval.
Specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. Enter a value between 1
and 25. The default is 1 second.
Specifies the data driven group expiry, in seconds. The user may specify a time
between 1 and 65535 with a default setting of 260 seconds.
The default is Disabled. If the field displays "Disabled", it will always be in MLD-
Snooping non-querier state.
Used to enable or disable the fast done state of the switch. This field is Disabled by
default.
Used to enable or disable MLD snooping for the specified VLAN. This field is
Disabled by default.
Used to enable or disable MLD Snooping report suppression for the specified VLAN.
Used to enable or disable MLD Snooping data driven learning for the specified
VLAN.
Used to Enable or Disable the aging out of MLD Snooping data driven learning for
the specified VLAN.
Used to configure the version of MLD used on switch. The default value is 2.
This read-only field describes the current querier state of the Switch, whether
Querier, which will send out Multicast Listener Query Messages to links, or Non-
111