Telligence™ Voice Command - Garmin GTN 725 Pilot's Manual

2.4 Telligence™ Voice Command
Garmin's Telligence Voice Command voice recognition feature allows
the pilot (and optionally copilot) to control the GTN 7XX connected
to a GMA 35 using spoken commands. To activate Voice Recognition,
push and hold the Push-to-Command (PTC) button while speaking a
command. When the Push-to-Command button is released, the GTN
7XX and/or the audio panel will respond.
If a command is understood by the GMA, a positive acknowledgement
chime will be played, and the relevant information will be displayed to
reflect the change (if applicable). The pilot should verify that the correct
response has occurred.
If a command is not understood by the GMA or the GTN is unable
to complete the requested action, a negative acknowledgement tone will
be played. The pilot should repeat the command by using the Push-to-
Command button, or by manually using the GTN 7XX touch screen. In
the event of any abnormal Voice Recognition operation, the front panel
controls and touch screen may be used to override Voice Recognition and
manually control the GTN 7XX.
NOTE 1: If Telligence Voice Command malfunctions and needs to be
disabled, remove power to the GMA 35 audio panel. This will force the
audio panel into the fail-safe mode. The pilot will be able to communicate
using the COM 2 radio only.
The following table lists the available Voice Recognition commands, the
associated actions, and the voice response if applicable:
190-01007-03 Rev. J
190-01007-03-Final.indb 25
Garmin GTN 725/750 Pilot's Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
2-25
Index
7/9/2015 2:06:58 PM