Enabling Autopilot Outputs For The King Kap140/Kfc225 - Garmin GTN 725 Pilot's Manual

1. "GPS" guidance may be used while flying outbound and on
2. "VLOC" guidance is used on the remainder of the approach
3. The localizer frequency must be active to use "VLOC" guidance
• When flying a localizer-based approach with automatic CDI switching
disabled.
1. You may select "VLOC" guidance at any point on the approach
2. The localizer frequency must be active to use "VLOC"
6.15 Enabling Autopilot Outputs for the
King KAP140/KFC225
Autopilot outputs for the King KAP140/KFC225 autopilots are activated
manually by the pilot after being prompted during the approach procedure. After
enabling outputs, the GTN 7XX will provide guidance information consistent
with what the autopilot expects (i.e., angular CDI scaling and glideslope capture
for an LPV or other vertically guided GPS approach).
Prompt To Activate
Autopilot Outputs
Touch To Activate
Autopilot Outputs
190-01007-03 Rev. J
190-01007-03-Final.indb 25
the initial portion of the procedure turn.
from the time you turn inbound on the procedure turn.
at the MAP.
prior to reaching the FAF.
guidance.
Figure 6-22 Prompt To Activate Autopilot Outputs
Garmin GTN 725/750 Pilot's Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
6-25
Index
7/9/2015 2:07:20 PM