Intercom Setup - Garmin GTN 725 Pilot's Manual

2.3

Intercom Setup

The GTN 7XX can operate as a control head for remotely connected
compatible intercom equipment. The Internal Communication System (ICS)
has several modes of operation that are selected on the display of the GTN 7XX
to control communication in the aircraft. Passengers cannot transmit over the
active Com radio, even if equipped with a PTT key.
Depending on the installation and aircraft, the pilot and co-pilot positions on
this page may be reversed (such as configured for rotorcraft).
1. Touch the Intercom window at the top of the display to
Selected
Intercom
Mode
2. Touch the arrow between the intercom recipients to activate
3. Touch the key for a function to the make the desired changes to
190-01007-03 Rev. J
190-01007-03-Final.indb 17
display the Intercom Setup page.
Figure 2-20 Intercom Setup
communication between those recipients. The arrow will be
green when communication is active. Touch the arrow again
to deactivate communication. Detailed information is shown
in the Intercom Modes table.
their setup. Then, touch the Back key to return to the Intercom
Setup page.
Garmin GTN 725/750 Pilot's Guide
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Touch To Display
Intercom Setup
Charts
Touch To Configure
Co-Pilot Volume
Wpt Info
And Squelch
Touch To Configure
Map
Pilot Volume And
Squelch
Traffic
Touch To Configure
Passenger Volume
Terrain
And Squelch
Weather
Touch Source
Nearest
To Configure
Services/
Music
Utilities
System
Messages
Symbols
Appendix
2-17
Index
7/9/2015 2:06:56 PM