Printronix P7000 User Manual page 343

Table 15. LCD Message Troubleshooting Table
Can User
Displayed Message
Correct?
UNDEF No
INTERRUPT*
UNDFNED No
OPCODE*
UNKNOWN RBN1 Yes
Install New RBN
UNKNOWN RBN2 Yes
Install New RBN
UP DRV. SHORT* No
WAITING FOR N/A
ETHERNET
ADAPTER
1
Before contacting an authorized service representative, power off the printer, wait 15
seconds, then power it back on and rerun your print job. If the message reappears,
press CLEAR. If the fault message still displays, then contact your authorized service
representative.
Explanation
Fatal firmware Contact your authorized
error on controller
service representative.
board.
Fatal firmware Contact your authorized
error on controller
service representative.
board.
Ribbon was not a Install a new ribbon.
Printronix coded
barcode.
Ribbon not Install a new ribbon.
authorized.
Hammer drive Cycle power to see if the
circuits on the message clears, if not,
boards shorted to contact your authorized
ground.
service representative.
Appears when the No action is required.
printer is first
powered on if the
optional Network
Interface Card is
installed.
Fault Messages
Solution
1
1
1
343