Configuring Ip Interworking Over An Ldp Pw - HP FlexNetwork HSR6600 Configuration Manual

Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpna
Peer
192.3.3.3
# Verify that an LDP PW has been established on PE 2.
[PE2] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpna
Peer
192.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring IP interworking over an LDP PW

Network requirements
CE 1 and PE 1 are connected through Ethernet interfaces. CE 2 and PE 2 are connected through
serial interfaces, and they use PPP as the link layer protocol.
Configure an LDP PW between PE 1 and PE 2 and enable interworking on PEs to allow
communication between CE 1 and CE 2.
Figure 112 Network diagram
Table 41 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
PW ID/Rmt Site
3
PW ID/Rmt Site
3
Interface IP address
GE1/1/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE1/1/1 -
GE1/1/2 10.1.1.1/24
Ser1/1/0 100.1.1.2/24
In/Out Label Proto
1279/1279 LDP
In/Out Label Proto
1279/1279 LDP
Device
P
PE 2
418
Flag Link ID State
M 1 Up
Flag Link ID State
M 1 Up
Interface IP address
Loop0 192.4.4.4/32
GE1/1/1 10.1.1.2/24
GE1/1/2 10.2.2.2/24
Loop0 192.3.3.3/32
Ser1/1/0 -