HP FlexNetwork HSR6600 Configuration Manual page 343

Step
3. Enter BGP VPNv6 address
family view.
4. Configure filtering of
advertised routes.
5. Configure filtering of
received routes.
6. Advertise the COMMUNITY
attribute to a peer or peer
group.
7. Configure ACL-based route
filtering for the specified peer
or peer group.
8. Configure BGP to not
change the next hop of
routes sent to a peer or peer
group.
9. Configure IPv6 prefix
list-based route filtering for
the specified peer or peer
group.
10. Specify a preferred value for
routes received from the
peer or peer group.
11. Configure BGP updates sent
to the peer to carry only
public AS numbers.
12. Apply a routing policy to
routes advertised to or
received from the peer or
peer group.
13. Enable route target filtering
for received BGP VPNv6
routes.
14. Configure the local PE as the
RR and specify the peer as
the client.
Command
address-family vpnv6
filter-policy { ipv6-acl-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
filter-policy { ipv6-acl-number |
prefix-list ipv6-prefix-name }
import
peer { group-name | ipv4-address
[ mask-length ] }
advertise-community
peer { group-name | ipv4-address
[ mask-length ] } filter-policy
ipv6-acl-number { export |
import }
peer { group-name | ipv4-address
[ mask-length ] }
next-hop-invariable
peer { group-name | ipv4-address
[ mask-length ] } prefix-list
ipv6-prefix-name { export |
import }
peer { group-name | ipv4-address
[ mask-length ] } preferred-value
value
peer { group-name | ipv4-address
[ mask-length ] } public-as-only
peer { group-name | ipv4-address
[ mask-length ] } route-policy
route-policy-name { export |
import }
policy vpn-target
peer { group-name | ipv4-address
[ mask-length ] } reflect-client
333
Remarks
N/A
By default, BGP does not filter
advertised routes.
By default, BGP does not filter
received routes.
By default, BGP does not
advertise the COMMUNITY
attribute to any peers or peer
groups.
By default, no ACL-based route
filtering is configured.
By default, the device sets itself
as the next hop for routes sent to
a peer or peer group.
In an inter-AS option C network
where an RR is used to advertise
VPNv6 routes, configure this
command on the RR so the RR
does not change the next hop of
routes sent to BGP peers and
clients.
By default, no IPv6 prefix
list-based route filtering is
configured.
The default preferred value is 0.
By default, a BGP update carries
both public and private AS
numbers.
By default, no routing policy is
applied for a peer.
By default, route target filtering is
enabled for received VPNv6
routes. Only VPNv6 routes whose
export route target attribute
matches local import route target
attribute are added to the routing
table.
By default, no RR or client is
configured.