Enabling Snmp Notifications For L2Vpn Pw - HP FlexNetwork HSR6600 Configuration Manual

use the reset arp command to clear the ARP entries on the CE before the CE can learn new
ARP entries.
•
When a CE is connected to a PE through a PPP link:
If the PE's interface connected to the CE has an IP address, the IPCP negotiation is performed.
If the interface does not have an IP address, perform one of the following operations:
Use the ppp ipcp ignore local-ip command to configure the PE to support IPCP
negotiation without an IP address.
Use the ppp ipcp proxy command to specify the IP address for IPCP negotiation with the
CE.
To configure interworking for a cross-connect:
Step
1. Enter system view.
2. Enter cross-connect group
view.
3. Enter cross-connect view.
4. Enable interworking for the
cross-connect.

Enabling SNMP notifications for L2VPN PW

This feature enables L2VPN to generate SNMP notifications when PW deletions, PW switchovers, or
PW status changes occur. For L2VPN event notifications to be sent correctly, you must also
configure SNMP on the device. For more information about SNMP configuration, see the network
management and monitoring configuration guide for the device.
To enable SNMP notifications for L2VPN PW:
Step
1. Enter system view.
2. Enable SNMP notifications
for L2VPN PW.
Displaying and maintaining MPLS L2VPN
Execute display commands in any view and reset commands in user view.
Task
Display LDP PW label information.
Display cross-connect forwarding
information (in standalone mode).
Display cross-connect forwarding
information (in IRF mode).
Display L2VPN information for Layer
3 interfaces bound to cross-connects.
Command
system-view
xconnect-group group-name
connection connection-name
interworking ipv4
Command
system-view
snmp-agent trap enable l2vpn
[ pw-delete | pw-switch |
pw-up-down ] *
Command
display l2vpn ldp [ peer ip-address [ pw-id pw-id ] |
xconnect-group group-name ] [ verbose ]
display l2vpn forwarding { ac | pw } [ xconnect-group
group-name ] [ slot slot-number ] [ verbose ]
display l2vpn forwarding { ac | pw } [ xconnect-group
group-name ] [ chassis chassis-number slot slot-number ]
[ verbose ]
display l2vpn interface [ xconnect-group group-name |
interface-type interface-number ] [ verbose ]
407
Remarks
N/A
N/A
N/A
By default, interworking is
disabled for a cross-connect.
Remarks
N/A
By default, SNMP notifications for
L2VPN PW are disabled.