Configuring Ipv6 Mpls L3Vpn Inter-As Option B - HP FlexNetwork HSR6600 Configuration Manual

# Configure PE 2.
[PE2] bgp 200
[PE2-bgp-default] peer 3.3.3.9 as-number 200
[PE2-bgp-default] peer 3.3.3.9 connect-interface loopback 0
[PE2-bgp-default] address-family vpnv6
[PE2-bgp-default-vpnv6] peer 3.3.3.9 enable
[PE2-bgp-default-vpnv6] quit
[PE2-bgp-default] quit
Verifying the configuration
# Verify that the CEs can learn the route to each other and can ping each other. (Details not shown.)

Configuring IPv6 MPLS L3VPN inter-AS option B

Network requirements
Site 1 and Site 2 belong to the same VPN. CE 1 of Site 1 accesses the network through PE 1 in AS
100, and CE 2 of Site 2 accesses the network through PE 2 in AS 600.
PEs in the same AS run IS-IS.
PE 1 and ASBR-PE 1 exchange VPNv6 routes through MP-IBGP. PE 2 and ASBR-PE 2 exchange
VPNv6 routes through MP-IBGP. ASBR-PE 1 and ASBR-PE 2 exchange VPNv6 routes through
MP-EBGP.
ASBRs do not perform route target filtering of received VPNv6 routes.
Figure 93 Network diagram
MPLS backbone
AS 100
PE 1
CE 1
AS 65001
Table 32 Interface and IP address assignment
Device
PE 1
Loop0
Ser1/1/1
Ser1/1/0
ASBR-PE 1
Loop0
Ser1/1/0
GE1/1/1
Site 1
Interface IP address
Loop0 2.2.2.9/32
GE1/1/1 30::1/64
Ser1/1/0 1.1.1.2/8
Loop0 MPLS backbone
Ser1/1/1
Ser1/1/0
ASBR-PE 2
Loop0
Ser1/1/0
GE1/1/1
Site 2
AS 65002
Device Interface
PE 2 Loop0
GE1/1/1
Ser1/1/0
356
AS 600
PE 2
CE 2
IP address
5.5.5.9/32
20::1/64
9.1.1.2/8