Displaying And Maintaining Static Srlsp - HP FlexNetwork HSR6600 Configuration Manual

Step
3. Set the MPLS TE tunnel
establishment mode to
static.
4. Bind a static SRLSP to the
MPLS TE tunnel interface.

Displaying and maintaining static SRLSP

Execute display commands in any view.
Task
Display static SRLSP and adjacency path
information.
Static SRLSP configuration examples
Network requirements
As shown in
Establish an MPLS TE tunnel over a static SRLSP from Router A to Router D to transmit data
between the IP networks. The static SRLSP traverses three segments: Router A-Router B, Router
B-Router C, and Router C-Router D.
Establish an MPLS TE tunnel over a static SRLSP from Router E to Router F to transmit data
between the IP networks. The static SRLSP traverses three segments: Router E-Router B, Router
B-Router C, and Router C-Router F.
Command
mpls te signaling static
mpls te static-sr-lsp lsp-name
Figure 141, Router A, Router B, Router C, Router D, Router E, and Router F run IS-IS.
Command
display mpls static-sr-lsp [ lsp lsp-name |
adjacency adjacency-path-name ]
547
Remarks
By default, MPLS TE uses
RSVP-TE to establish a tunnel.
By default, an MPLS TE tunnel
does not use a static SRLSP.