HP FlexNetwork HSR6600 Configuration Manual page 483

# Configure basic MPLS.
<NPE3> system-view
[NPE3] interface loopback 0
[NPE3-LoopBack0] ip address 4.4.4.9 32
[NPE3-LoopBack0] quit
[NPE3] mpls lsr-id 4.4.4.9
[NPE3] mpls ldp
[NPE3–ldp] quit
# Enable L2VPN.
[NPE3] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish N-PWs to NPE
1 and NPE 2.
[NPE3] vsi aaa
[NPE3-vsi-aaa] pwsignal ldp
[NPE3-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500
[NPE3-vsi-aaa-ldp-2.2.2.9-500] quit
[NPE3-vsi-aaa-ldp] peer 3.3.3.9 pw-id 500
[NPE3-vsi-aaa-ldp-3.3.3.9-500] quit
[NPE3-vsi-aaa-ldp] quit
[NPE3-vsi-aaa] quit
# Bind Layer 3 Ethernet interface GigabitEthernet 1/1/1 to VSI aaa.
[NPE3] interface gigabitethernet 1/1/1
[NPE3-GigabitEthernet1/1/1] xconnect vsi aaa
[NPE3-GigabitEthernet1/1/1] quit
Verifying the configuration
# Verify that PWs in up state have been established on each PE.
[UPE] display l2vpn pw verbose
VSI Name: aaa
Peer: 2.2.2.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
[NPE1] display l2vpn pw verbose
VSI Name: aaa
Peer: 1.1.1.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
PW ID: 500
: LDP
: 8 PW State : Up
: 1277 Out Label: 1277
: 1500
: Main
: -
: -
: 0x460000000
: 1030
PW ID: 500
: LDP
: 8 PW State : Up
: 1277 Out Label: 1277
: 1500
: Main, No-split-horizon
: -
: -
473