HP FlexNetwork HSR6600 Configuration Manual page 64

[RouterD-GigabitEthernet1/1/1] mpls ldp enable
[RouterD-GigabitEthernet1/1/1] quit
[RouterD] interface gigabitethernet 1/1/2
[RouterD-GigabitEthernet1/1/2] mpls enable
[RouterD-GigabitEthernet1/1/2] mpls ldp enable
[RouterD-GigabitEthernet1/1/2] quit
# Configure Router A.
[RouterA] mpls lsr-id 2.2.2.2
[RouterA] mpls ldp
[RouterA-mpls-ldp] quit
[RouterA] interface gigabitethernet 1/1/1
[RouterA-GigabitEthernet1/1/1] mpls enable
[RouterA-GigabitEthernet1/1/1] mpls ldp enable
[RouterA-GigabitEthernet1/1/1] quit
[RouterA] interface gigabitethernet 1/1/2
[RouterA-GigabitEthernet1/1/2] mpls enable
[RouterA-GigabitEthernet1/1/2] mpls ldp enable
[RouterA-GigabitEthernet1/1/2] quit
5. Configure IPv4 LSP generation policies so LDP uses all static routes and IGP routes to
establish LSPs:
# Configure Router S.
[RouterS] mpls ldp
[RouterS-ldp] lsp-trigger all
[RouterS-ldp] quit
# Configure Router D.
[RouterD] mpls ldp
[RouterD-ldp] lsp-trigger all
[RouterD-ldp] quit
# Configure Router A.
[RouterA] mpls ldp
[RouterA-ldp] lsp-trigger all
[RouterA-ldp] quit
Verifying the configuration
# Verify that primary and backup LSPs have been established.
[RouterS] display mpls ldp lsp 21.1.1.0 24
Status Flags: * - stale, L - liberal, B - backup
FECs: 1
FEC
21.1.1.0/24
Ingress: 2
In/Out Label
-/1276
2174/1276
-/1276(B)
2174/1276(B)
54
Transit: 2 Egress: 0
Nexthop OutInterface
13.13.13.2 GE1/1/2
13.13.13.2 GE1/1/2
12.12.12.2 GE1/1/1
12.12.12.2 GE1/1/1