IBM xSeries 445 Type 8870 Option Installation Manual page 74

Figure 60. Routing cables through the cable management arm
4. Connect the SMP Expansion cables to the secondary server:
62
xSeries 445 Type 8870: Option Installation Guide
c. Connect one end of a 2.5 m (8.2 feet) SMP Expansion cable to port 1 of
SMP Expansion Module 1 on the primary server; then, route the cable
through the cable-management arm as in step 3a on page 61.
d. Connect one end of a 2.5 m (8.2 feet) SMP Expansion cable to port 2 of
SMP Expansion Module 1 on the primary server; then, route the cable
through the cable-management arm as in step 3b on page 61.
e. Verify that a 25.4 cm (10 inches) SMP Expansion cable is connected
between port 3 of SMP Expansion Module 0 and port 3 of SMP Expansion
Module 1.
a. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
b. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 2. Next, route the cable
through the secondary cable-management arm.
c. Locate the SMP Expansion cable that is connected to port 1 of SMP
Expansion Module 1 on the primary server; then, connect the opposite end
of the cable to port 1 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
d. Locate the SMP Expansion cable that is connected to port 2 of SMP
Expansion Module 0 on the primary server; then, connect the opposite end
of the cable to port 2 of SMP Expansion Module 3. Next, route the cable
through the secondary cable-management arm.
e. Verify that a 25.4 cm (10 inches) SMP Expansion cable is connected
between port 3 of SMP Expansion Module 2 and port 3 of SMP Expansion
Module 3.
Cable-management arm
Long SMP expansion cables