Closing the cover
Complete the following steps to install the server cover:
1. Close the cover by first closing the right side; then, close the left side and press
Figure 53. Closing the cover
2. Reconnect all external cables and power cords to the server; then, connect the
3. Slide the server into the rack enclosure until it stops; then, secure the server in
4. Turn on your server.
down to latch the two halves of the cover in place.
power cords to properly grounded electrical outlets. See Chapter 3, "I/O
connectors and LEDs", on page 75 for connector locations.
the rack enclosure using the quick release latches.
Chapter 2. Installing options
57