IBM xSeries 445 Type 8870 Option Installation Manual page 36

Connect to
SCSI backplane
Figure 16. Location of preinstalled SCSI cable
24
xSeries 445 Type 8870: Option Installation Guide
2. Turn off the server and disconnect all power cords and external cables; then,
open the server cover (see "Opening the cover" on page 16).
3. Remove fans 3 and 4, which are located just behind the PCI-X slots.
4. Disconnect the short SCSI cable from the SCSI backplane and the integrated
SCSI controller on the I/O board; then, store this short cable in a safe place for
future use.
5. Install the ServeRAID adapter in a PCI-X slot (see"PCI and PCI-X adapters" on
page 20).
6. Locate one end of the preinstalled SCSI cable and connect it to the
ServeRAID adapter.
Preinstalled
SCSI cable
7. Locate the other end of the preinstalled SCSI cable and connect it to the SCSI
backplane.
Connect to
ServeRAID adapter