Replacing The Battery - IBM xSeries 445 Type 8870 Option Installation Manual

Replacing the battery

When replacing the battery you must replace it with a lithium battery of the same
type, from the same manufacturer. To avoid possible danger, read and follow the
safety statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your server and reset the
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
system date and time.
1. Read the safety information beginning on page v and "Installation guidelines"
on page 9; then, follow any special handling and installation instructions
supplied with the replacement battery.
2. Turn off the server and peripheral devices, disconnect the power cords, and all
external cables from the server; then, open the cover (see "Opening the cover"
on page 16 for details).
3. Remove fans 3 and 4 from the server (see "Replacing fans 3 and 4" on
page 53 for details).
4. While standing in front of the server, locate the battery on the I/O planar just
under the leading edge of the PCI-X planar. With the fans removed the battery
is visible from the front of the server.
Chapter 2. Installing options
55