IBM xSeries 445 Type 8870 Option Installation Manual page 45

7. Loosen the blue thumbscrews securing the EMC shield; then, remove the EMC
shield from the server.
EMC shields
Thumbscrews
For use with one
SMP Module
Figure 25. EMC shields
8. Grasp each of the locking levers on the top of the SMP Expansion Module, and
lift them up slightly.
9. Working from the right side of the server, rotate the two locking levers toward
you until they are fully extended, as shown.
Latch
Figure 26. Rotate the locking levers to remove the SMP Expansion Module
Attention: When removing the SMP Expansion Module from the server, lift it
out carefully, taking care not to damage the components on the center plane.
10. Use the handle and the finger relief on the SMP Expansion Module cover to
carefully lift the SMP Expansion Module out of the server.
11. Remove the SMP Expansion Module cover:
a. Place the SMP Expansion Module on a flat, level surface.
Thumbscrews
For use with two
SMP Modules
Locking
levers
Finger relief
Handle
Chapter 2. Installing options
33