IBM xSeries 445 Type 8870 Option Installation Manual page 68

Figure 51. Removing the battery
Figure 52. Installing the battery
10. Turn on the server.
11. Start the Configuration/Setup Utility program and set configuration parameters.
56
xSeries 445 Type 8870: Option Installation Guide
5. Remove the battery:
a. Use one finger to press the top of the battery clip away from the battery.
b. Lift and remove the battery from the socket.
6. Insert the new battery:
a. Position the battery so that the positive (+) symbol is facing away from you.
b. Use one finger to press the top of the battery clip away from the battery.
c. Press the battery into the socket until it clicks into place. Make sure that
the battery clip holds the battery securely.
7. Install fans 3 and 4 in the server (see "Replacing fans 3 and 4" on page 53 for
details).
8. Close the server cover, and connect the cables.
9. Slide the server into the rack enclosure until it stops; then, secure the server in
the rack enclosure using the quick release latches.
v Set the system date and time.
v Set the power-on password.
v Reconfigure your server.