Specifying An End Receiver - Ricoh aficio 350 Operating Instructions Manual

ADVANCED TRANSMISSION FEATURES
The following display is shown.
Note
The numbers of Transfer Sta-
tions and End Receivers are dis-
played.
I
Press the { { { { Start} } } } key.

Specifying an End Receiver

4
When you make a Transfer Request,
you must specify the final destina-
tions (End Receivers) for your mes-
sage.
You cannot enter the numbers of the
End Receivers directly. Instead, enter
a simple code that describes where
the numbers are stored in the Trans-
fer Station (in Quick Dials, Speed Di-
als or Groups).
The numbers must first have been
stored in Quick Dials, Speed Dials or
Groups in the Transfer Station(s).
Quick Dial
Enter { { { { q } } } } followed by the num-
ber (2 digits) of the Quick Dial
where the End Receiver is stored.
For example, to choose the number
stored in Quick Dial 01 in the
Transfer Station, enter: { { { { q } } } } { { { { 0} } } }
{ { { { 1} } } }
Speed Dial
Enter { { { { q } } } } , { { { { p} } } } followed by the
Speed Dial code (2 or 3 digits).
For example, to choose the number
stored in Speed Dial 12 in the
Transfer Station, enter:{ { { { q } } } } { { { { p} } } }
{ { { { 1} } } } { { { { 2} } } }
98
Group Dial
Enter{ { { { q } } } } , { { { { p} } } } , { { { { p} } } } followed
by the Group number (2 digits).
For example, to choose the number
stored in Group 04 in the Transfer
Station, enter:{ { { { q } } } } { { { { p} } } } { { { { p} } } } { { { { 0
} } } } { { { { 4} } } }