Problem Creating Aps - Samsung WEC8500 Maintenance Manual

WEC8500/8050 Maintenance Manual
3.3

Problem Creating APs

To create an AP to the APC, the AP is configured using CLI/WEC.
Symptoms
When attempting to create AP executing 'ap [ap config name]', the AP is not added.
WEC8500# configure terminal
WEC8500/configure# ap ap_test123
[configApConfig] createApFromCfgName failed. (sApCfgName:ap_test123,
apId:-1, ret:-20)
Possible Causes
The APs has been already configured as many as the number of TotalApNo
TotalApNo is the same as MaxApNo, additional APs cannot be configured.
TotalApNo is the total number of APs that are configured additionally; and MaxApNo is
the maximum number of APs that can be set up additionally.
The procedure to add APs using web UI is described below.
1) On the top menu, click Configuration.
2) On the left menu, click Access Points.
3) Click Add.
4) Click the Security tab.
5) Set AP Profile Name and MAC Address, and click Apply to create an AP.
Solutions
1) Execute the 'show apc summary' command to check TotalApNo, which is set in the
APC.
WEC8500# show apc summary
===== APC Summary =====
ApcName
AP Mgmt interface IP
MaxApNo
ActiveApNo
TotalApNo
802.11a/n Radios
802.11b/g/n Radios
ActiveStationNo
SecurityAuthType
RMacField
DtlsPolicy
Samsung Electronics America
: APC_007e37001ff0
: 100.100.100.1 (vlan1.100)
: 3000
: 22
: 3000
: 22/2978
: 22/2978
: 0
: X.509
: Support
: Both
Version 5.1
page 67 of 87