WEC8500/8050 Maintenance Manual
3.1.3
AP registration error
Symptoms
The AP information is not registered.
WEC8500# show ap summary
AP Mgnt interface IP : 10.10.10.11 (vlan1.110)
AP_ID
Profile
State Location
====== ========== ================== ================ ================
===== ===========
Possible Causes
The AutoDiscovery function is off and the AP information is not registered.
Checking and Solving the Problem
1) Check if the AP information (MAC information is used as the identifier of each AP) is
registered in the APC.
2) Check if the AutoDiscovery function is enabled.
[Checking the AutoDiscovery Function]
If the AutoDiscovery function is enabled for the APC, when an AP sends a discovery
request to the APC, it is automatically registered.
The registered information is not deleted.
If the AutoDiscovery function is disabled, the AP information must be manually
registered in the APC.
WEC8500/configure# show apc capwap summary
===== Capwap Summary =====
capwap control source port number : 5246
capwap data source port number
capwap control DTLS mode
capwap WindowSize
capwap ChangeStatePendingTimer
capwap DataCheckTimer
capwap DtlsSessionDelete
capwap RetransmitInterval
capwap WaitDTLSTimer
capwap WaitJoinTimer
capwap DiscoveryDeleteTimer
capwap MaxRetransmit
capwap MutalAuth
Samsung Electronics America
AP_NAME
MAC_Address
: 5247
: Support
: 10
: 25
: 30
: 1
: 5
: 60
: 60
: 10
: 5
: Enable
Version 5.1
IPv4Addr
page 61 of 87