Spectrum Analysis Is Not Provided - Samsung WEC8500 Maintenance Manual

WEC8500/8050 Maintenance Manual
2.3.2

Spectrum analysis is not provided

This can occur if spectrum analysis is not setup or there is a problem with the connection
between the APC and the AP.
Symptoms
Reporting function of spectrum analysis is not provided.
Possible Causes

The reporting function is not enabled.

There is an error with the Control And Provisioning Wireless Access Point (CAPWAP)
which is the connection between the APC and the AP.
Solutions
1) Check the spectrum analysis setting of the AP.
WEC8500# show spectrum-analysis config ap 1
...
Report Settings:
Sample Report (FFT)................................... Disabled
Interference Report................................... Enabled
Duty Cycle Report..................................... Disabled
...
If Report Settings of spectrum analysis is not in 'Enable' state, enter the following
command.
Samsung Electronics America
Figure 6. Web UI-Clustering function does not work
Version 5.1
page 52 of 87