Lexus NX300 Owner's Manual page 99

ON mode, in addition to the above for
the opening operations, the back door
operates for any of the following condi-
tions:
• Parking brake is engaged
• The brake pedal is depressed
• The shift lever is in P
*
: When configured with the customization
function so that it can be operated after
being unlocked, operate the back door
after it has been unlocked.
■ Kick sensor (vehicles with power back
door and kick sensor)
The power back door will open/close auto-
matically when the kick sensor operation is
enabled (→P.100) and the following condi-
tions are met:
● The power back door is fully closed/
opened.
The electronic key is within the opera-
●
tional range. (→P.108)
● A foot is put near the lower center part of
the rear bumper and moved away from
the rear bumper.
The power back door may also be operated
by putting a hand, an elbow, a knee, etc.
near the lower center part of the rear
bumper and moving it away from the rear
bumper. Make sure to put it close enough to
the center part of the rear bumper.
■ Back door closer
In the event that the back door is left slightly
open, the back door closer will automati-
cally close it to the fully closed position.
Whatever the state of the engine switch, the
back door closer operates.
■ Operation of the power back door
● A buzzer sounds and the emergency
flashers flash twice to indicate that the
back door is opening/closing.
When the power back door operations
●
are OFF, the power back door does not
operate but it can be opened and closed
by hand.
● When the power back door automati-
cally opens, if an abnormality due to peo-
LEXUS NX300
al_USA_OM78211U
3-2. Opening, closing and locking the doors
Owners Manu-
ple or objects is detected, operation will
stop.
■ Close & lock function
When the power back door is open, this
function closes the power back door and
then locks all of the doors simultaneously.
When the following procedures are per-
formed and there are no electronic keys for
the vehicle within the vehicle, all of the
doors will lock when the power back door is
completely closed.
1
Close all of the doors except the power
back door.
2 While carrying an electronic key, press
the switch on the lower part of
the power back door (→P.97).
A different buzzer than the normal one will
sound and then the power back door will
begin closing automatically. When the
power back door is closed, all of the doors
will lock simultaneously and operation sig-
nals will indicate that all of the doors have
been locked.
■ Situations in which the close & lock
function may not operate properly
(vehicles with power back door and kick
sensor)
In the following situations, the close & lock
function may not operate properly:
If the switch on the lower part of
●
the power back door (→P.97) is pressed
by a hand which is holding an electronic
key
● If the switch on the lower part of
the power back door (→P.97) is pressed
when the electronic key is in a bag, etc.
that is placed on the ground
● If the switch on the lower part of
the power back door (→P.97) is pressed
with the electronic key not near the vehi-
cle.
■ Situations in which the kick sensor may
operate unintentionally (vehicles with
power back door and kick sensor)
In the following situations, the kick sensor
101
3