Lexus NX300 Owner's Manual page 185

WARNING
Keep the windshield clean at all times.
●
• If the windshield is dirty or covered
with an oily film, water droplets, snow,
etc., clear the windshield.
• If a glass coating agent is applied to the
windshield, it will still be necessary to
use the windshield wipers to remove
water droplets, etc. from the area of
the windshield in front of the camera
sensor.
• If the inner side of the windshield
where the camera sensor is installed is
dirty, contact your Lexus dealer.
● Do not attach objects, such as stickers,
transparent stickers, etc., and so forth,
to the outer side of the windshield in
front of the camera sensor (shaded
area in the illustration).
A From the top of the windshield to
approximately 0.4 in. (1 cm) below
the bottom of the camera sensor
B Approximately 7.9 in. (20 cm)
(Approximately 4.0 in. (10 cm) to the
right and left from the center of the
camera sensor)
● If the part of the windshield in front of
the camera sensor is fogged up or
covered with condensation or ice, use
the windshield defogger to remove the
fog, condensation or ice. (→P.255)
LEXUS NX300
al_USA_OM78211U
4-5. Using the driving support systems
Owners Manu-
● If water droplets cannot be properly
removed from the area of the wind-
shield in front of the camera sensor by
the windshield wipers, replace the
wiper insert or wiper blade.
If the wiper inserts or wiper blades
need to be replaced, contact your
Lexus dealer.
Do not attach window tinting to the
●
windshield.
Replace the windshield if it is damaged
●
or cracked.
If the windshield needs to be replaced,
contact your Lexus dealer.
● Do not get the camera sensor wet.
● Do not allow bright lights to shine into
the camera sensor.
● Do not dirty or damage the camera
sensor.
When cleaning the inside of the wind-
shield, do not allow glass cleaner to
contact the lens. Also, do not touch the
lens.
If the lens is dirty or damaged, contact
your Lexus dealer.
Do not subject the camera sensor to a
●
strong impact.
Do not change the installation position
●
or direction of the camera sensor or
remove it.
Do not disassemble the camera sen-
●
sor.
● Do not modify any components of the
vehicle around the camera sensor
(inside rear view mirror, etc.) or ceiling.
● Do not attach any accessories that
may obstruct the camera sensor to the
hood, front grille or front bumper.
Contact your Lexus dealer for details.
If a surfboard or other long object is to
●
be mounted on the roof, make sure
that it will not obstruct the camera sen-
sor.
187
4