NOTICE
Preventing sensor malfunctions
■
If the area around a sensor is subjected
●
to an impact, equipment may not oper-
ate properly due to a sensor malfunc-
tion. Have the vehicle inspected by
your Lexus dealer.
When using a high-pressure washer to
●
wash the vehicle, do not spray water
directly on the sensors. The sensors
may not function properly if subjected
to an impact from strong water pres-
sure.
When using steam to wash the vehicle,
●
do not direct steam too close to the
sensors. The sensors may not function
properly if subjected to steam.
Changing settings of the Park-
ing Support Brake function (for
static objects)
This system can be enabled/disabled
on the multi-information display.
1
Press "
" or "
control switches and select
2
Press "
" or "
control switches and select
3
Press
on the meter control
switches to enable/disable the sys-
Operation
Engine output restraint control
■
When there is an obstacle, where a potential collision may occur, is detected, the
increase of the vehicle speed is restrained due to engine output being controlled.
LEXUS
NX300
al_USA_OM78211U
4-5. Using the driving support systems
" of the meter
.
" of the meter
.
Owners
Manu-
tem.
The PKSB OFF indicator comes on
when the Parking Support Brake
function is OFF (not operating).
When the Parking Support Brake func-
tion is switched OFF, system operation
does not resume until the function is
switched back ON through the set-
tings screen on the multi-information
display. (System operation does not
resume by operating the engine
switch.)
When removing and installing the bat-
■
tery
The system needs to be initialized.
The system can be initialized by driving the
vehicle straight ahead for 5 seconds or
more at a speed of approximately 35 km/h
(22 mph) or higher.
221
4