Lexus NX300 Owner's Manual page 191

ity", and press
desired setting.
1
Far
The warning will begin to operate earlier
than with the default timing.
2 Middle
This is the default setting.
3 Near
The warning will begin to operate later
than with the default timing.
Operational conditions
■
The pre-collision system is enabled and the
system determines that the possibility of a
frontal collision with a vehicle or pedestrian
is high.
Each function is operational at the following
speeds:
● Pre-collision warning:
• Vehicle speed is between approximately
7 and 110 mph (10 and 180 km/h). (For
detecting a pedestrian, vehicle speed is
between approximately 7 and 50 mph
[10 and 80 km/h].)
• The relative speed between your vehicle
and the vehicle or pedestrian ahead is
approximately 7 mph (10 km/h) or more.
Pre-collision brake assist:
●
• Vehicle speed is between approximately
20 and 110 mph (30 and 180 km/h). (For
LEXUS NX300
al_USA_OM78211U
4-5. Using the driving support systems
to select the
Owners Manu-
detecting a pedestrian, vehicle speed is
between approximately 20 and 50 mph
[30 and 80 km/h].)
• The relative speed between your vehicle
and the vehicle or pedestrian ahead is
approximately 20 mph (30 km/h) or
more.
● Pre-collision braking:
• Vehicle speed is between approximately
7 and 110 mph (10 and 180 km/h). (For
detecting a pedestrian, vehicle speed is
between approximately 7 and 50 mph
[10 and 80 km/h].)
• The relative speed between your vehicle
and the vehicle or pedestrian ahead is
approximately 7 mph (10 km/h) or more.
The system may not operate in the following
situations:
If a battery terminal has been discon-
●
nected and reconnected and then the
vehicle has not been driven for a certain
amount of time
● If the shift lever is in R
If VSC is disabled (only the pre-collision
●
warning function will be operational)
■ Pedestrian detection function
The pre-collision system detects pedestri-
ans based on the size, profile, and motion of
a detected object. However, a pedestrian
may not be detected depending on the sur-
rounding brightness and the motion, pos-
ture, and angle of the detected object,
preventing the system from operating prop-
erly. (→P.195)
■ Cancelation of the pre-collision braking
If either of the following occur while the
pre-collision braking function is operating, it
will be canceled:
The accelerator pedal is depressed
●
strongly.
193
4