Intuitive Parking Assist - Lexus NX300 Owner's Manual

214
4-5. Using the driving support systems

Intuitive parking assist

*
: If equipped
The distance from your vehicle to
nearby obstacles when parallel
parking or maneuvering into a
garage is measured by the sensors
and communicated via the displays
and a buzzer. Always check the sur-
rounding area when using this sys-
tem.
WARNING
When using the intuitive parking
■
assist
Observe the following precautions.
Failing to do so may result in the vehicle
being unable to be driven safely and pos-
sibly cause an accident.
● Do not use the sensor at speeds in
excess of 6 mph (10 km/h).
● The sensors' detection areas and reac-
tion times are limited. When moving
forward or reversing, check the areas
surrounding the vehicle (especially the
sides of the vehicle) for safety, and
drive slowly, using the brake to control
the vehicle's speed.
Do not install accessories within the
●
sensors' detection areas.
NOTICE
■ When using intuitive parking assist
In the following situations, the system
may not function correctly due to a sen-
sor malfunction, etc. Have the vehicle
checked by your Lexus dealer.
● The intuitive parking assist operation
display flashes, and a buzzer sounds
when no obstacles are detected.
If the area around a sensor collides
●
with something, or is subjected to
strong impact.
LEXUS NX300
al_USA_OM78211U
*
Owners Manu-
● If the bumper collides with something.
If the display shows continuously with-
●
out beeping, except when the buzzer
mute switch has been turned on.
If a display error occurs, first check the
●
sensor.
If the error occurs even if there is no
ice, snow or mud on the sensor, it is
likely that the sensor is malfunctioning.
System components
Types of sensors
■
Front corner sensors
A
Front center sensors
B
Rear corner sensors
C
Rear center sensors
D
Turning intuitive parking assist on/
■
off
Intuitive parking assist can be enabled/
disabled on the multi-information dis-
play as following:
1 Press " " or " " of meter con-
trol switches and select
2
Press " " or " " of meter con-
trol switches and select
3
Press to select the desired set-
ting (on/off).
.
.