Lexus NX300 Owner's Manual page 206

208
4-5. Using the driving support systems
Setting the vehicle speed (vehi-
cle-to-vehicle distance control
mode)
1 Press the "ON/OFF" button to
activate the cruise control.
Radar cruise control indicator will come on
and a message will be displayed on the
multi-information display.
Press the button again to deactivate the
cruise control.
If the "ON/OFF" button is pressed and
held for 1.5 seconds or more, the system
turns on in constant speed control mode.
(→P.211)
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 30 mph [50 km/h])
and push the lever down to set the
speed.
Cruise control "SET" indicator will come
on.
The vehicle speed at the moment the lever
is released becomes the set speed.
If the lever is operated while the vehicle
speed is below approximately 30 mph (50
km/h) and a preceding vehicle is present,
the set speed will be adjusted to approxi-
mately 30 mph (50 km/h).
LEXUS NX300
al_USA_OM78211U
Owners Manu-
Adjusting the set speed
To change the set speed, operate the
lever until the desired set speed is dis-
played.
1
Increases the speed
(Except when the vehicle has been
stopped by system control in vehicle-to-
vehicle distance control mode)
2
Decreases the speed
Fine adjustment: Momentarily move
the lever in the desired direction.
Large adjustment: Hold the lever up or
down to change the speed, and release
when the desired speed is reached.
In the vehicle-to-vehicle distance con-
trol mode, the set speed will be
increased or decreased as follows:
For the U.S. mainland and Hawaii

Fine adjustment: By 1 mph (1.6 km/h)
*2
km/h (0.6mph) each time the lever is
*1
or 1