Other Interior Features - Lexus NX300 Owner's Manual

5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the Owner's
manual supplied with the garage door
opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
Perform 3 within 30 seconds after
performing 2.
3 Press and hold the desired Home-
®
Link button (inside the vehicle)
LEXUS NX300
al_USA_OM78211U
5-5. Using the other interior features
®
buttons.
Owners Manu-
for 2 seconds and release it. Repeat
this sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
opener motor recognizes the
®
HomeLink signal.
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
device compatibility, refer to
www.HomeLink.com.)
1
Within 5 seconds after program-
ming the garage door opener has
been completed, if the garage door
opener motor is trained to Home-
®
Link , both garage door operation
indicators will flash rapidly green
and the light on the garage door
opener motor will blink twice, indi-
287
®
5