Table of Contents
Advertisement
If the fiber has to pass through a metallic board hole, the hole must have a sleek and fully filleted
•
surface (the filleting radius must be not less than 2 mm). When passing through a metallic board
hole or bending along the acute side of mechanical parts, the fiber must wear jackets or cushions.
•
Insert and remove a plug with care. Never exert a fierce force to the fiber or plug; otherwise the
plug may be damaged or the fiber may be broken. Never pull, press or extrude the fiber fiercely.
For the allowed maximum tensile load and crush load, see
SFP+ cable
You can use SFP+ cables to connect SFP+ ports. The SFP+ cables available for the switch are 10 G SFP+
Cu cables, as shown in
Figure 50 SFP+ cable
(1) Connector
QSFP+ cable
You can use QSFP+ cables to connect QSFP+ ports.
Figure 51 QSFP+ cable
(1) Connector
QSFP+ to SFP+ cable
A QSFP+ to SFP+ cable is a cable with one QSFP+ module at one end and four SFP+ modules at the
other end.
Figure
50.
84
Table
50.
(2) Pull latch
(2) Pull latch
Advertisement
Table of Contents
Troubleshooting
