HP FlexFabric 11908-V Installation Manual page 18

Installing cable management brackets
The 1 1908-V has two cable management brackets: the cable management brackets are installed at the
upper part of the switch, and the power cable management brackets are installed at the lower part of the
switch. They are installed in the same way. For more information, see
To install a cable management bracket:
1. Unpack the cable management brackets.
2. Attach the cable management bracket to the chassis, and align the screws with the mounting holes
on the chassis, as shown in
3. Fasten the screws.
Figure 8 Attaching cable management brackets to a 11908-V
(1) Attach the cable management bracket to the chassis.
(2) Mounting holes for installing the cable management bracket.
(3) Screws for attaching the cable management bracket to the chassis.
(4) Cable management bracket (installed at the upper part of the chassis).
(5) Power cable management bracket (installed at the lower part of the chassis).
Attaching mounting brackets to the chassis
1. Identify the left mounting bracket (marked L) and the right mounting bracket (marked R) on the
inner surface of the mounting brackets.
2. Facing the chassis front, mount the left and right mounting brackets to the two sides of the chassis,
as shown in
Figure
Figure 9.
8.
12
Figure 8.