HP FlexFabric 11908-V Installation Manual page 29

2. Remove the filler panel (if any) from the target slot. Keep the filler panel for future use. See callout
1 on Figure 17.
3. Loosen the captive screws on the protection box on the switching fabric module for the 11908-V
switch, hold the ejector levers on the switching fabric module, pressing the buttons on the levers,
pull the ejector levers outward, and pull out the module. See
Keep the protection box for future use.
4. Hold the switching fabric module by the front panel with one hand and support its bottom with the
other. Slide the switching fabric module steadily into the slot along the guide rails.
Do not touch the components on the PCB.
5. As shown in callout 1 in
levers touch the slot edges tightly.
6. As shown in callout 2 in
panel tightly and the switching fabric module seats into the backplane.
7. As shown in callout 3 in
Figure 18 Removing the protection box
(1) Loosen the captive screws
(3) Pull the ejector levers outward
Figure 19, push the switching fabric module until the brakes on the ejector
Figure 19, press the ejector levers inward until the ejector levers touch the
Figure 19, fasten the captive screws on the switching fabric module.
23
Figure 18.
(2) Press down the buttons
(4) Pull out the switching fabric module