Mounting The Switch To The Rack - HP FlexFabric 11908-V Installation Manual

Figure 9 Installing the mounting brackets to a 11908-V
1
3
(1) Screws for attaching the mounting brackets to the chassis
(2) Mounting brackets
(3) Fasten the screws

Mounting the switch to the rack

CAUTION:
Do not hold the handle of the fan tray, power supply, or the back cover of the chassis, or the air vents of
•
chassis. Any attempt to carry the switch with these parts may cause equipment damage or even bodily
injury.
• After placing the switch on the slide rails, do not let go right away because this may tip the switch,
damage the switch, or cause bodily injury.
To mount the switch to the rack:
1. Move the chassis to face the rear of the chassis towards the front of the rack.
2. Use at least two people to lift the switch by using the handles or supporting the bottom of the
chassis until the bottom of the switch is a little higher than the slide rails on the rack.
2
2
13
1
3