Configuring Ipv6 Multicast Access Control; Configuration Prerequisites; Enabling Ipv6 Multicast Access Control; Configuring An Mld User Access Policy - HP VSR1000 Configuration Manual

To enable IPv6 multicast load splitting on an MLD proxy:
Step
Enter system view.
1.
Enter MLD view.
2.
Enable IPv6 multicast load
3.
splitting on an MLD proxy.

Configuring IPv6 multicast access control

Configure the IPv6 multicast access control feature on the BRAS.

Configuration prerequisites

Before you configure the IPv6 multicast access control feature, complete the following tasks:
Configure an IPv6 unicast routing protocol so that all devices in the domain can interoperate at
1.
the network layer.
Configure basic MLD features.
2.

Enabling IPv6 multicast access control

Perform this task on an interface of the BRAS where you want to control the downstream users'
access to IPv6 multicast traffic.
To enable IPv6 multicast access control:
Step
Enter system view.
1.
Enter Layer 3 Ethernet
2.
interface view, Layer 3
Ethernet subinterface view,
Layer 3 aggregate interface
view, Layer 3 aggregate
subinterface view, or VT
interface view.
Enable IPv6 multicast access
3.
control.

Configuring an MLD user access policy

This feature enables the BRAS to filter MLD reports by using an ACL that specifies the IPv6 multicast
groups in a user profile. Use this feature to control the IPv6 multicast groups that an MLD user can
join.
You can also configure an IPv6 multicast group list on the RADIUS server to achieve the same
purpose. A user can join an IPv6 multicast group if the group is in the group list.
Command
system-view
mld [ vpn-instance
vpn-instance-name ]
proxy multipath
Command
system-view
interface interface-type
{ interface-number |
interface-number.subnumber }
mld authorization-enable
242
Remarks
N/A
N/A
By default, IPv6 multicast load
splitting is disabled on an MLD
proxy, and only the proxy
interface with the highest IP
address forwards IPv6 multicast
data.
Remarks
N/A
N/A
By default, IPv6 multicast access
control is disabled.