Configuration Prerequisites; Enabling Ipv6 Bidir-Pim - HP VSR1000 Configuration Manual

Tasks at a glance
Configuring a BSR
•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
BSMs out of their incoming interfaces
(Optional.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure IPv6 BIDIR-PIM, configure an IPv6 unicast routing protocol so that all devices
in the domain can interoperate at the network layer.

Enabling IPv6 BIDIR-PIM

Because IPv6 BIDIR-PIM is implemented on the basis of IPv6 PIM-SM, you must enable IPv6
PIM-SM before enabling IPv6 BIDIR-PIM. As a best practice, enable IPv6 PIM-SM on all non-border
interfaces on routers when you deploy an IPv6 BIDIR-PIM domain.
IMPORTANT:
All interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 BIDIR-PIM:
Step
Enter system view.
1.
Enable IPv6 multicast routing
2.
and enter MRIB view.
Return to system view.
3.
Enter interface view.
4.
Enable IPv6 PIM-SM.
5.
Return to system view.
6.
Enter IPv6 PIM view
7.
Enable IPv6 BIDIR-PIM
8.
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling BSM semantic fragmentation
Disabling the device from forwarding
Configuring common IPv6 PIM features
Enabling SNMP notifications for IPv6 PIM
Configuring common IPv6 PIM features
Command
system-view
ipv6 multicast routing
[ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
ipv6 pim sm
quit
ipv6 pim [ vpn-instance
vpn-instance-name ]
bidir-pim enable
292
Remarks
Skip the task of configuring a BSR on an IPv6
network without C-RPs.
N/A
N/A
N/A
Remarks
N/A
By default, IPv6 multicast routing
is disabled.
N/A
N/A
By default, IPv6 PIM-SM is
disabled.
N/A
N/A
By default, IPv6 BIDIR-SM is
disabled.