HP VSR1000 Configuration Manual page 331

[RouterA-GigabitEthernet1/0/1] quit
# Enable IPv6 PIM-SM on other interfaces.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] ipv6 pim sm
[RouterA-GigabitEthernet1/0/2] quit
[RouterA] interface gigabitethernet 1/0/3
[RouterA-GigabitEthernet1/0/3] ipv6 pim sm
[RouterA-GigabitEthernet1/0/3] quit
# Enable IPv6 multicast routing, MLD and IPv6 PIM-SM on Router B and Router C in the same
way Router A is configured. (Details not shown.)
# Enable IPv6 multicast routing and IPv6 PIM-SM on Router D and Router E in the same way
Router A is configured. (Details not shown.)
Configure the IPv6 SSM group range FF3E::/64 on Router A.
4.
[RouterA] acl ipv6 basic 2000
[RouterA-acl-ipv6-basic-2000] rule permit source ff3e:: 64
[RouterA-acl-ipv6-basic-2000] quit
[RouterA] ipv6 pim
[RouterA-pim6] ssm-policy 2000
[RouterA-pim6] quit
Configure the IPv6 SSM group range on Router B, Router C, Router D and Router E in the
5.
same way Router A is configured. (Details not shown.)
Verifying the configuration
# Display IPv6 PIM information on Router A.
[RouterA] display ipv6 pim interface
Interface
GE1/0/1
GE1/0/2
GE1/0/3
# Send an MLDv2 report from Host A to join IPv6 multicast source and group (4001::100/64,
FF3E::101). (Details not shown.)
# Display IPv6 PIM multicast routing table information on Router A.
[RouterA] display ipv6 pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF3E::101)
Protocol: pim-ssm, Flag:
UpTime: 00:00:11
Upstream interface: GigabitEthernet1/0/2
Upstream neighbor: 1002::2
RPF prime neighbor: 1002::2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet1/0/1
# Display IPv6 PIM multicast routing table information on Router D.
[RouterD] display ipv6 pim routing-table
NbrCnt HelloInt
0 30
1 30
1 30
Protocol: mld, UpTime: 00:00:11, Expires: 00:03:25
DR-Pri DR-Address
1 FE80::A01:201:1
(local)
1 FE80::A01:201:2
1 FE80::A01:201:3
323