Switching On For The First Time; Quick Start Menu - Siemens Sirius 3RW44 System Manual

Commissioning
5.2

Switching on for the first time

5.2.1 Quick start menu

5-4
Warning
Before switching the unit on for the first time, verify that the main/
control side is wired properly. Make sure that the supply and control
voltage comply with the device-specific requirements (refer to
Chapter 9.3 Technical
Important
After applying the control supply voltage for the first time, you will automatically
be in the quick start menu which you must go through once for to commission
the soft starter for the first time.
In the quick start menu you need to enter information to preset the most
important parameters of the soft starter for the application. Starting parameters
that are typical of the application are stored in the device parameters.
To achieve an optimum motor start, these parameters may need to be optimized
in relation to the connected load by using the Settings menu item, as described
in Chapter 5.4.3 Determining the starting mode .
If you are unable to find your load among the available suggestions, select any
load and optimize the defined parameters using the Settings menu item as
described in Chapter 5.4.3 Determining the starting mode if required.
The factory values of the parameters as well as the predefined assignment of
the control inputs and outputs can be found in Chapter 9.3 Technical data.
If you confirm the last item Save settings - Run? with Yes in the quick start
menu, you can only return to this menu by resetting the device back to the
factory setting (refer to Chapter 2.5 Factory setting). This overwrites all settings
made up until that point.
data).
SIRIUS 3RW44 manual
GWA 4NEB 535 2195-02 DS 01