Ifc Local Rs-232 Flow Control - NetComm NTC-6000 Series Command Manual

+IFC Local RS-232 flow control

This parameter is used to control the operation of local flow control between the terminal
and the local DTE.
.
Default: 0,0
Command values:
AT+IFC=<DCE_by_DTE>,<DTE_by_DCE>†
Where:
<DCE_by_DTE>
<DTE_by_DCE>
The valid numeric variables for the +IFC command are as follows:
By default, the modem is set up as AT+IFC=2,2 to allow hardware flow
control in both directions.
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
Storage: &W
Specifies the method to be used by the DTE to control
the flow of received data from the DCE.
Specifies the method to be used by the DCE to control
the flow of transmitted data from the DTE.
0 No Flow Control
2 Hardware
Page 16 of 32
7/21/2010