Sdsr Configuration; Cdcd Configuration; Nri Configuration - NetComm NTC-6000 Series Command Manual

&S DSR Configuration
This parameter determines how the terminal controls the state of the DSR circuit.
Default: &S0
Command values:
&S0 DSR always ON.
&S1 DSR ON when signal present and phone registered on network.
&S2 DSR ON when cellular packet data session established.
&S3 DSR always OFF
&C DCD Configuration
This parameter determines how the terminal controls the state of the DCD circuit.
Default: &C1
Command values:
&C0 DCD always ON.
&C1 DCD ON when connected to remote host.
&C2 DCD always OFF.
&C3 DCD ON when cellular PPP session established.
&N RI Configuration
This parameter determines how the terminal controls the state of the RI circuit.
Default: &N1
Command values:
&N0 RI always ON.
&N1 RI simulates incoming ring.
&N2 RI always OFF.
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
Storage: &W
Storage: &W
Storage: &W
Page 14 of 32
7/21/2010