Extended Syntax Commands - NetComm NTC-6000 Series Command Manual

following this number, either a "?" or " " character shall appear. "?" is used to read the
current value of the indicated S-parameter; " " is used to set the S-parameter to a new
value.
S parameter_number ?
S parameter_number [ value ]
If the " " is used, the new value to be stored in the S-parameter is specified in decimal
following the " ". If no value is given (i.e. the end of the command line occurs or the next
command follows immediately), an ERROR result code issued and the stored value left
unchanged.
The ranges of acceptable values are given in the description of each S-parameter.
If the "?" is used, the terminal transmits a single line of information text to the host.
This information text consists of exactly three characters, giving the value of the S-
parameter in decimal, with leading zeroes included.

Extended syntax commands

Both actions and parameters have names, which are used in the related commands. Names
always begin with the character " " or "^".
Following the" " or "^", from one to sixteen (16) additional characters appear in the
command name.
The command interpreter in the terminal considers lower-case characters to be the same as
their upper-case equivalents.
Values
When subparameters are associated with the execution of an action, or when setting a
parameter, the command may include specification of values. This is indicated by the
appearance of value in the descriptions below.
NTC-6000 Series V.250 Manual Page 8 of 32
To suit software version 1.1.0 7/21/2010