Miscellaneous, System, Test And Diagnostic Commands; Reset Reset The Cellular Router; Factory Reset The Cellular Router Configuration; Copt Configuration Options - NetComm NTC-6000 Series Command Manual

Miscellaneous, system, test and diagnostic commands

^RESET Reset the cellular router
This command initiates a soft reset (reboot) of the NTC, any active PAD and
cellular packet data sessions are abruptly terminated.
Default: N/A
Command values:
N/A
^FACTORY Reset the cellular router configuration
This command resets the cellular routers configuration to factory defaults, this resets
ALL configuration data.
Default: N/A
Command values:
N/A
^COPT Configuration options.
This command can be used to show or set a number of terminal specific options.
The command expects / returns an integer value between 0 and 255 which
represents a bitmap of various options.
Default: 0
Command values:
^COPT=<bitmap>
Where the bits in <bitmap> are defined as follows: -
1 Banner off
2 Connect message off Do not show connection progress messages.
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
Storage: NA
Storage: Automatic
Storage: Automatic
Do not show power on welcome message.
Page 27 of 32
7/21/2010