Gasc Enable Cellular Packet Session Auto Connect; Grst End Cellular Packet Session - NetComm NTC-6000 Series Command Manual

11) APN:
^GASC Enable cellular packet session auto connect
Enables or disables automatic connection and log-in to the cellular packet network.
Default:
Command values:
^GASC=0 Do not connect to cellular packet network.
^GASC=1 Connect to cellular packet network using profile 1
^GASC=2 Connect to cellular packet network using profile 2
^GASC=3 Connect to cellular packet network using profile 3
^GASC=4 Connect to cellular packet network using profile 4
^GASC=5 Connect to cellular packet network using profile 5
^GASC=6 Connect to cellular packet network using profile 6
^GRST End Cellular Packet Session
This command will kill the current cellular packet session and bring the modem to
Command State. NOTE: This command will tear down the cellular packet session in
an orderly manner and may take several seconds to complete.
Default:
Command values:
^GRST
NOTE: If ^GASC=1, the modem will detect that the session dropped and will
immediately reconnect. To fully disconnect, set ^GASC=0 and then issue the
^GRST command.
NTC-6000 Series V.250 Manual
To suit software version 1.1.0
zzzzz – Port to listen to in server mode.
Access Point Name of network to connect to.
0 Storage: Automatic
N/A Storage: N/A
Kills the current cellular packet session.
Page 21 of 32
7/21/2010