Genie Z-45 Operator's Manual page 31

Fourth Edition • First Printing
Test the Drive Enable System
33 Press down the foot switch
and lower the boom to the
stowed position.
34 Rotate the turntable until
the boom moves past one
of the non-steer wheels.
Result: The drive enable indicator light should
come on and remain on while the boom is
anywhere in the range shown.
35 Move the drive control handle off center.
Result: The drive function should not operate.
36 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive chassis
to identify the direction of
travel.
Part No. 114358 Z-45/25 DC • Z-45/25J DC • Z-45/25 Bi-Energy • Z-45/25J Bi-Energy
Test Limited Drive Speed
37 Press down the foot switch.
38 Raise the primary boom approximately 90 cm.
39 Slowly move the drive control handle to the full
40 Lower the primary boom to the stowed position.
41 Raise the secondary boom approximately
42 Slowly move the drive control handle to the full
43 Lower the secondary boom to the stowed
44 Extend the primary boom approximately
Blue
45 Slowly move the drive control handle to the full
Yellow
46 Retract the boom.
If the drive speed with the primary boom raised, the
secondary boom raised or the primary boom
extended exceeds 30 cm per second, immediately
tag and remove the machine from service.
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
30 cm per second.
90 cm.
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 30 cm per second.
position.
60 cm.
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 30 cm per second.
Operator's Manual
Inspections
29