Genie Z-45 Operator's Manual page 20

Operator's Manual
Controls
Ground Control Panel
1 Platform rotate switch
Move the platform rotate
switch to the right and the
platform will rotate to the
right. Move the platform
rotate switch to the left and
the platform will rotate to the
left.
2 Turntable rotate switch
Move the switch to the right and
the turntable will move to the
right. Move the switch to the
left and the turntable will move
to the left.
3 Primary boom up/down switch
Move the switch up and the
primary boom will raise. Move
the switch down and the
primary boom will lower.
4 Primary boom extend/retract
switch
Move the switch to the left
and the boom will extend.
Move the switch to the right
and the boom will retract.
5 Used for optional equipment
6 Bi-Energy models: Engine idle (rpm) select
switch
Move the switch to the left (turtle) for low idle.
Move the switch to the right (rabbit) for high idle
and quickest battery charging.
7 Auxiliary power switch
Use auxiliary power if the primary power source
fails.
Simultaneously hold the auxiliary power switch
to either side and activate the desired function.
18 Z-45/25 DC • Z-45/25J DC • Z-45/25 Bi-Energy • Z-45/25J Bi-Energy
Fourth Edition • First Printing
8 Key switch for platform/off/ground selection
Turn the key switch to the platform position and
the platform controls will operate. Turn the key
switch to the off position and the machine will
be off. Turn the key switch to the ground
position and the ground controls will operate.
9 Red Emergency Stop button
Push in the red Emergency Stop button to the
off position to stop all functions. Pull out the red
Emergency Stop button to the on position to
operate the machine.
10 Platform overload indicator light
Light flashing indicates the platform is
overloaded and no functions will operate.
Remove weight from the platform until the light
goes off.
11 Hour meter
The hour meter displays the number of hours the
machine has operated.
12 Bi-Energy models: Glow plug switch
Move the glow plug switch to either side and
hold for 3 to 5 seconds.
13 Function enable switch
Move the function enable switch to either side to
enable the functions on the ground control panel
to operate.
14 Bi-Energy models: Engine start switch
Move the engine start switch to either side to
start the engine.
Part No. 114358