Genie Z-45 Operator's Manual page 24

Operator's Manual
Controls
Platform Control Panel
1 Horn button
Push the horn button and the horn will sound.
Release the horn button and the horn will stop.
2 Auxiliary power switch
Use auxiliary power if the primary power source
fails.
Simultaneously hold the auxiliary power switch
to either side and activate the desired function.
3 Drive enable indicator light
Light on indicates that the boom has moved just
past either non-steer wheel and drive function
has been interrupted.
4 Drive enable switch
To drive when the drive enable light is on, hold
the drive enable switch to either side and slowly
move the drive control handle off center. Be
aware that the machine may move in the
opposite direction that the drive and steer
controls are moved.
5 Z-45/25J: Jib boom up/down switch
Move the switch up and the
jib boom will raise. Move the
switch down and the jib boom
will lower.
6 Platform rotate switch
Move the platform rotate
switch to the right and the
platform will rotate to the
right. Move the platform
rotate switch to the left
and the platform will rotate
to the left.
22 Z-45/25 DC • Z-45/25J DC • Z-45/25 Bi-Energy • Z-45/25J Bi-Energy
Fourth Edition • First Printing
7 Platform level switch
Move the platform level
switch up and the level of
the platform will raise. Move
the platform level switch
down and the level of the
platform will lower.
8 Used for optional equipment
9 Bi-Energy models: Glow plug switch
Move the glow plug switch to either side and
hold for 3 to 5 seconds.
10 Bi-Energy models: Engine start switch
Move the engine start switch to either side to
start the engine.
11 Bi-Energy models: Engine idle (rpm) select
switch
Move the switch to the left (rabbit & foot switch)
for foot switch activated high idle.
Move the switch to the center (turtle) for low
idle.
Move the switch to the right (rabbit) for high idle
and quickest battery charging.
12 Platform overload indicator light
Light flashing indicates the platform is
overloaded and no functions will operate.
Remove weight from the platform until the light
goes off.
13 Machine not level indicator light
The machine not level indicator light will come
on when the tilt alarm sounds.
Part No. 114358