Siemens SINUMERIK 840D sl Configuration Manual page 137

Procedure
To directly view after a configuration change (or after the compile) which I/O addresses differ
from the standard schema, proceed as follows:
1. Click "General" or "Compile" in the "Info" inspector window.
The message log is displayed.
Figure 5-5
The inspector window has the following options:
– All components and telegrams that differ from the default scheme are listed in the
– To switch directly to the detail view of the respective component or I/O address, click
– To call the associated help entry in the information system of the TIA Portal, click the
2. Note the required information.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325
The "Info > General" inspector window shows which default I/O addresses were
already assigned for each individual telegram.
"Message" column.
the symbol in the "Go to" column.
symbol in the "?" column.
Configuring telegrams and drive units
5.9 Deviations from the standard I/O addressing schematic
137