Mark And Save A Spot-Lock; Start Spot-Lock Navigation; Mark A Spot-Lock At The Boat Position; Mark A Spot-Lock At The Cursor Position - Humminbird i-PILOT LINK Operation Manual

Mark and Save a Spot-Lock

Use the following instructions to mark a Spot-Lock at the boat position. The Spot-Lock will be saved, but navigation will not start.
The Spot-Lock is saved to the Waypoint Management dialog box. You can edit the name, etc. See Edit a Saved Spot-Lock for
more information.

Mark a Spot-Lock at the Boat Position

1. Press the MARK key.
2. Select Spot-Lock.
3. Press the RIGHT Cursor key.

Mark a Spot-Lock at the Cursor Position

1. Use the Cursor Control key to move the cursor to a position on the chart.
2. Press the MARK key.
3. Select Spot-Lock.
4. Press the RIGHT Cursor key.

Start Spot-Lock Navigation

You can quickly Spot-Lock at the current boat position or the cursor position, and start navigation towards it automatically. This
type of Spot-Lock is temporary, and unless you save it, the Spot-Lock will be deleted when you start a new mode of navigation. To
save a Spot-Lock, see Mark and Save a Spot-Lock.
Engage Spot-Lock at the Boat Position
1a. Press the GO TO key twice.
OR
1b. Press the GO TO key once.
2. Select Spot-Lock at Vessel. Press the RIGHT Cursor key.
CAUTION! Be prepared for boat movement as the prop will automatically be enabled and the prop speed will automatically adjust
to move the boat to the Spot-Lock position. If the boat does not move, confirm the prop is turned on in the menu system (see
Propeller Controls).